Skip to main content
Qargo

Tasks – Complete tasks in bulk

Complete tasks in bulk across Orders, Loads, and Invoices, including retriggering pallet labels after destination changes for both Qargo-generated and network labels.

Table of contents
  1. How to retrigger pallet labels in bulk
  2. Troubleshooting

Several pages have an option that allows mass updates for specific tasks. This option is under the Quick actions drop-down. The available menu items depend on the page.
​

Tasks can be completed in bulk on the following pages:

Summary to complete tasks:

  • Navigate to Orders, Loads, or Invoices
  • Click Quick actions
  • Click the task to perform.
  • Select the orders by row to include them in the task update
  • Click the green Save button to update the tasks.

How to retrigger pallet labels in bulk

After destinations change on multiple orders, updated pallet labels can be regenerated in bulk. The right method depends on whether the label is Qargo-generated (a PDF task configured in Qargo) or a network label retrieved from a carrier (for example, Palletforce or Palletline).


Scenario 1: Qargo-generated pallet labels (Orders page)

Bulk retriggering is available directly from the Orders page through Quick actions. The key step is enabling the option to include already-completed tasks, which makes them available for re-execution.

Steps

  1. Navigate to the Orders page and filter to the affected orders (for example, the 15 orders with changed destinations).
  2. Click Quick actions in the top right of the orders list.
  3. Under the Tasks section, select the relevant label task (for example, Pallet Label or Create label).
  4. In the order selection screen, scroll to the bottom and enable “Include completed tasks” (or “Re-trigger completed tasks”) to make already-completed label tasks selectable again.
  5. Select all the relevant orders.
  6. Click Execute. Label generation is retriggered across all selected orders at once.

Scenario 2: Network labels (Palletforce, Palletline, etc.)

Network labels are automatically generated (or re-fetched) when a dispatch task is completed. Retriggering the dispatch on the Load page sends updated order data to the carrier, which returns fresh labels.

Steps

  1. Navigate to the Load page (Planning > Loads or Operations > Shipments).
  2. Select the relevant load(s) containing the updated orders.
  3. Click Quick actions.
  4. Locate the dispatch task (for example, Dispatch to Palletforce or Send to network).
  5. Select the loads to redispatch. If they have already been dispatched and need to be retriggered in bulk, make sure that “include completed tasks” is enabled at the bottom of the load selection screen.
  6. Qargo redispatches the updated order data to the network. Fresh labels are automatically generated and attached to the orders.

Troubleshooting

Issue Likely cause Resolution
Orders don’t appear in the Quick actions task list Completed tasks are hidden by default Scroll to the bottom of the order selection screen and enable “Include completed tasks”
Label generated but the destination info is still old The dispatch was not retriggered (for network labels) Retrigger the dispatch task from the Load page. The carrier needs updated data before issuing a new label
Network label still shows the old destination after redispatch Network processing delay Wait a few minutes and refresh. If the issue persists, check the dispatch task status for errors
Quick actions task is grayed out or not selectable The orders may already be at a non-applicable status Check the order status. Some task triggers have status preconditions configured in the workflow